![]() Strip the outer cable jacket by using the utility knife to gently slice through the outer insulation.īe careful while doing this to ensure you don't cut too deep and damage the insulation on the individual wires. Read Also > How To Install 200-Volt Well Pump Wiring? Verify there is no power on the wire you are hooking up by using your voltage tester.Ĭarefully use one probe to touch the end of a hot wire while touching the other probe to a ground wire your meter should read zero volts. You can use wire that is rated higher than the amperage rating of your plug but you CANNOT use wire that is rated lower! Step 2 - Verify There is No Power
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |